1901-1953 Indian Motorcycle – Parts – Accessories

Shopping cart
$0.00
  1. Home
  2. Knowledge Base
  3. Indian Factory Service Shots
  4. 1950 Service Shots
  5. Service Bulletin 2-23 Check Wire Connections To Prevent Damage To Voltage Regulators

Service Bulletin 2-23 Check Wire Connections To Prevent Damage To Voltage Regulators

CHECK WIRE CONNECTIONS TO PREVENT DAMAGE TO VOLTAGE REGULATORS

Wire connections from generator to voltage regulator should be checked on all 1950 Warriors.

  1. The wire leading from the LEFT HAND terminal on the generator (the terminal nearest to the cam case side of the engine) must be connected to the terminal on the regulator marked “FLD” (field).
  2. The wire leading from the RIGHT HAND terminal on the generator (the terminal nearest to the primary drive case side of the engine) must be connected to the terminal on the regulator marked “GEN” (generator).

Incorrect connection of these wires will damage the voltage regulator when the engine is started.

NOTE: Please refer to the wiring diagram on Page 24 in the Arrow and Scout Riders’ Instruction Book for correct wire connections, as described above.

SERVICE DEPARTMENT

Was this article helpful?

Related Articles

Leave a Comment

Leave a Reply

Need Support?

Can't find the answer you're looking for?
Contact Support