202 – Mounting Indian Commander Horns

MOUNTING INDIAN COMANDER HORNS

Indian “Commander” Horns are the most popular motorcycle horns on the market. However, for best results, they must be properly mounted to the motorcycle front safety guards. The following procedure should be used.

1. Screw the hex studs “B” onto the rear horn mounting bolts “A”.
2. Insert washers “C” into end of spring pate “D”.
3. Place “D” under top of front safety guard, spring plate toward rear. Set clamp “E” over top of guard through holes in plate. Install and tighten the clamp nuts.
4. Mount horn with studs “B” and washers “C” smooth side down over spring plate holes “C” and assemble bolts “F” through bottom of plate “D” into studs “B”.
5. Adjust horn in upright position, close to tank and tighten securely.
6. Remove standard horn(supplied on machine) and mount relay “G” in its place at center of safety guard.
   Note: When Flat washers are supplied, mount on top of spring plate holes “C” under hex studs “B” with smooth edge down on plate.
7. Attach battery wire to center terminal (marked “B”)
8. Attach wire “H” to relay terminal (marked “H”) and to terminal on horn cap.

Horn is now ready for use. Opposite horn mounts on other side of safety guard.

Note: Horns to be mounted on safety guard only.