194 – 348 Model Instrument Light Socket Conversion To Overcome Bulb Failures

348 MODEL INSTRUMENT LIGHT SOCKET CONVERSION TO OVERCOME BULB FAILURES

1. Remove instrument panel cover.
2. Remove left gas tank
3. Remove instrument and light panel bracket.
4. Unsolder the wires on the bulb sockets.
5. Solder one wire 7″ long and one wire 8″ long on new socket, as shown in sketch. (SPEEDOMETER LIGHT)
6. Solder new wire 8″ long and generator indicator light wire from harness on other new socket, as shown in sketch.
7. Cut instrument and light panel bracket, as shown in sketch, and reassemble on frame. Replace gas tank.
8. Insert both bulb sockets half way through rubber pad. Assemble pad over panel stud and adjust pad to lie flat on top of gas tank. Connect wires on switch as shown.
9. Assemble bulbs in sockets with bulb shock ring on the generator indicator light bulb.
10. Replace instrument panel.

NOTE: Please use attached order blank when ordering the parts you need. One set of parts includes:

These parts sent no charge on request. Send orders to Walt Brown, Service Department.